[NM] Problem with NM1 and Cubase

[Martin Hoppe]

I am almost sure that happens because Cubase is sending a midi controller
value at stop. Make sure, your patch does not have any controllers assigned
(use the F9-key to see the assigned midi controllers) then try again. Good
luck...

-----Ursprüngliche Nachricht-----
Von: nord-modular-bounces at electro-music.com
[mailto:nord-modular-bounces at electro-music.com] Im Auftrag von Ole
Gesendet: Dienstag, 3. Juli 2007 20:45
An: Nord Modular mailing list
Betreff: [NM] Problem with NM1 and Cubase

Hi,
(my first message to the list).

I've bought a NM Classic and created a patch that I am controlling from
Cubase. Everything works well recording in Cubase and replaying through
Cubase untill I press "Stop" after that my NM turns several octaves down in
pitch ! It will only play properly after I turn the synth off and back on
again. However, the same thing happens when I hit "stop" in my sequencer and
try to play again.  Do anyone have a clue to what might be wrong in my
setup?

best regards
ole 

___________________________________________________________
Nord-modular mailing list
Nord-modular at electro-music.com
http://mail.electro-music.com/mailman/listinfo/nord-modular

Members: use http://mail.electro-music.com/mailman/options/nord-modular
to change subscription status, digest options, password, topics, etc.

Patches sent to the Nord-Modular mailing list may not be redistributed
without the express consent of the author/creator.
___________________________________________________________